A practical reference on RP-HPLC: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-10-03 and is reviewed periodically as new material appears.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
==== Nitrogen ==== The nitrogen stable isotope system is based on the relative enrichment/depletion of 15N in comparison to 14N in δ15N. Carbon and nitrogen stable isotope analyses are complementary in paleodiet studies. Nitrogen isotopes in bone collagen are ultimately derived from dietary protein, while carbon can be contributed by protein, carbohydrate, or fat. δ13C values help distinguish between dietary protein and plant sources while systematic increases in δ15N values as you move up in trophic level helps determine the position of protein sources in the food web. 15N increases 3-4% with each trophic step upward. It has been suggested that the relative difference between human δ15N values and animal protein values scales with the proportion of that animal protein in the diet, though this interpretation has been questioned due to contradictory views on the impact of nitrogen intake through protein consumption and nitrogen loss through waste release on 15N enrichment in the body. Variations in nitrogen values within the same trophic level are also considered. Nitrogen variations in plants, for example, can be caused by plant-specific reliance on nitrogen gas which causes the plant to mirror atmospheric values. Enriched or higher δ15N values can be achieved in plants that grew in soil fertilized by animal waste. Nitrogen isotopes have been used to estimate the relative contributions of legumes verses nonlegumes, as well as terrestrial versus marine resources.
Dyspnea on exertion Paroxysmal nocturnal dyspnea Fever Weight loss (see cachexia) Lightheadedness or syncope (Loss of consciousness) Hemoptysis Sudden death Tachycardia or milder heartrate, i.e. 75–100 cycl/min
Protactinium (91Pa) has no stable isotopes. As 231Pa occurs in usable quantity, and comprises virtually all of the element, it defines the standard atomic weight. Thirty radioisotopes of protactinium have been characterized, ranging from 210Pa to 239Pa. The most stable isotopes are 231Pa with a half-life of 32,700 years, 233Pa with a half-life of 26.975 days, and 230Pa with a half-life of 17.4 days. All of the remaining radioactive isotopes have half-lives less than 1.6 days, and the majority of these have half-lives less than 1.8 seconds. This element also has five meta states, 217mPa (t1/2 1.15 milliseconds), 220m1Pa (t1/2 = 308 nanoseconds), 220m2Pa (t1/2 = 69 nanoseconds), 229mPa (t1/2 = 420 nanoseconds), and 234mPa (t1/2 = 1.16 minutes). The only naturally occurring isotopes are 231Pa, 233Pa, 234Pa, and 234mPa. The first occurs as an intermediate decay product of 235U, the second of (rare) 237Np, and the last two as intermediate decay products of 238U. 231Pa dominates solely because of its longer life. The primary decay mode for protactinium isotopes lighter than (and including) the most stable isotope 231Pa is alpha decay to isotopes of actinium, except 228Pa to 230Pa, which primarily decay by electron capture to isotopes of thorium. The primary mode for the heavier isotopes is beta minus (β−) decay to isotopes of uranium.
Sources: en.wikipedia.org
== Awards and honors == Tanzi has received numerous awards, including the two highest awards for Alzheimer's disease research: The Metlife Foundation Award for Medical Research in Alzheimer's Disease Award and The Potamkin Prize. He was included on the list of the "Harvard 100 Most Influential Alumni", and was chosen by the Geoffrey Beene Foundation as a “Rock Star of Science”. In 2015, he was named by Time to the Time 100 Most Influential People in the World list. In 2018, Tanzi was inducted into the Rhode Island Heritage Hall of Fame. He was also inducted into the Cranston Hall of Fame in 2000. Tanzi was awarded an honorary doctorate from The University of Rhode Island on May 17, 2015.
=== Phase 2a clinical trial – ABSSSI === Initial Treatment for Acute Bacterial Skin Infections (ABSSSI) Caused by Staphylococcus aureus Randomized, Dose Ranging, Active Controlled Efficacy and Safety Evaluation of PMX-30063 As Initial Treatment for Acute Bacterial Skin and Skin Structure Infections (ABSSSI) Caused by Staphylococcus aureus The study started in October 2010 and had a primary completion date of December 2011 for final data collection for the primary outcome measure. Overall, 215 patients were randomized into either one of the three brilacidin arms or the active comparator Daptomycin arm. There were three dosing regimens for brilacidin, a low, medium and high dose administered for three days, and one dosing regimen for Daptomycin administered for seven days. The clinical trial was successful, demonstrating safety and clinical efficacy for all evaluated doses of brilacidin, with three-day brilacidin cure rates of all dosing regimens comparable with seven days of Daptomycin. The results indicated the potential for a shorter brilacidin dosing regimen. Shorter dosing regimens are important as they reduce the risks from Intravenous therapy complications, reduce costs such as reduced hospital stays and clinic visits, and can help reduce the emergence of antibiotic resistance through a combination of a quick bacterial kill, shorter duration of treatment, and increased patient compliance.
=== Integumentary === The integumentary system is the set of organs forming the outermost layer of the human body, comprising the skin, hair, and nails. It acts as a protective physical barrier between the external environment and the internal environment, while maintaining water balance, protecting deeper tissue, excreting waste, and regulating body temperature. The skin (or, integument) is a composite organ, made up of the outermost epidermis and the inner dermis. The epidermis comprises five layers: the stratum corneum, stratum granulosum, stratum spinosum and stratum basale. Where the skin is thicker, such as in the palms and soles, there is an extra layer of skin between the stratum corneum and the stratum granulosum known as the stratum lucidum. The dermis comprises two sections, the papillary and reticular layers, and contains connective tissues, blood vessels, glands, follicles, hair roots, sensory nerve endings, and muscular tissue. Between the integument and the deep body musculature there is a transitional subcutaneous zone, the hypodermis.
=== Impregnation === Due to its low viscosity while retaining solvent capacities, supercritical carbon dioxide is also used for impregnation of different raw materials. The biggest industrial application in this field is impregnation of wood with biocides. The big advantage is, that the CO2 can penetrate the complete structure of the board, carrying the active ingredient and therefore fully impregnating it.
Sources: en.wikipedia.org
== Biography == Mikhail Tsvet was born on 14 May 1872 in Asti, Italy. His mother was Italian, and his father was a Russian official. His mother died soon after his birth, and he was raised in Geneva, Switzerland. He received his BS degree from the Department of Physics and Mathematics at the University of Geneva in 1893. However, he decided to dedicate himself to botany and received his PhD degree in 1896 for his work on cell physiology. He moved to Saint Petersburg, Russia, in 1896 because his father was recalled from the foreign service. There, he started to work at the Biological Laboratory of the Russian Academy of Sciences. His Geneva degrees were not recognized in Russia, and he had to earn Russian degrees. In 1897, he became a teacher of botany courses for women. In 1902, he became a laboratory assistant at the Institute of Plant Physiology of the Warsaw University (now in Poland). In 1903, he became an assistant professor and also taught at other Warsaw universities. After the beginning of World War I, the Warsaw University of Technology was evacuated to Moscow, Russia, and in 1916 again to Gorki near Moscow. In 1917, he became a Professor of Botany and the director of the botanical gardens at the University of Tartu (then Yuryev). In February 1918, before German troops conquered the Estonian city, Tsvet along with most of the Russian academic staff of the university evacuated to Voronezh in Central Russia. Tsvet died of a chronic inflammation of the throat on 26 June 1919 at the age of 47.
Both religions revere John the Baptist, Saint George, and Elijah. Druze, believe that Elijah came back as John the Baptist, or as Saint George, since they belief in reincarnation and the transmigration of the soul, Druze believe that El Khidr and John the Baptist and Saint George are one and the same. Elijah is a central figure of Druzism, and he considered patron of the Druze people. Due to the Christian influence on the Druze faith, two Christian saints become the Druze's favorite venerated figures: Saint George and the Prophet Elijah. Thus, in all the villages inhabited by the Druze and Christians in central Mount Lebanon, a Christian church or Druze maqam is dedicated to either the Prophet Elijah or Saint George. The reverence for Saint George, who is often identified with Al-Khidr, is deeply integrated into various aspects of Druze culture and religious practices. According to scholar Ray Jabre Mouawad, the Druze appreciated the two saints for their bravery, Saint George because he confronted the dragon and the Prophet Elijah because he competed with the pagan priests of Baal and won over them. In both cases the explanations provided by Christians are that Druzes were attracted to warrior saints that resemble their own militarized society. The Druze environment influenced in turn the Christians, and Christians living among Druze started to adopt the same word for some of their churches, using maqām instead of kanīsah (church). Saint George is seen as a guardian of the Druze community and a symbol of their enduring faith and resilience.
== Data management == The FDA has collected a large amount of data through the decades. The OpenFDA project was created to enable easy access of the data for the public and was officially launched in June 2014.
The 62-ton Ivy Mike device built by the United States and exploded on 1 November 1952, was the first fully successful hydrogen bomb (thermonuclear bomb). In this context, it was the first bomb in which most of the energy released came from nuclear reaction stages that followed the primary nuclear fission stage of the atomic bomb. The Ivy Mike bomb was a factory-like building, rather than a deliverable weapon. At its center, a very large cylindrical, insulated vacuum flask or cryostat, held cryogenic liquid deuterium in a volume of about 1000 liters (160 kilograms in mass, if this volume had been completely filled). Then, a conventional atomic bomb (the "primary") at one end of the bomb was used to create the conditions of extreme temperature and pressure that were needed to set off the thermonuclear reaction. Within a few years, so-called "dry" hydrogen bombs were developed that did not need cryogenic hydrogen. Released information suggests that all thermonuclear weapons built since then contain chemical compounds of deuterium and lithium in their secondary stages. The material that contains the deuterium is mostly lithium deuteride, with the lithium consisting of the isotope lithium-6. When the lithium-6 is bombarded with fast neutrons from the atomic bomb, tritium (hydrogen-3) is produced, and then the deuterium and the tritium quickly engage in thermonuclear fusion, releasing abundant energy, helium-4, and even more free neutrons. "Pure" fusion weapons such as the Tsar Bomba are believed to be obsolete.
=== Cryogenics === The branches of engineering that involve the study of very low temperatures (ultra low temperature i.e. below 123 K), how to produce them, and how materials behave at those temperatures.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.