A practical reference on mass spectrometry: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-08-01 and is reviewed periodically as new material appears.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It was derived from the ACTH(4-10) fragment, a short segment of adrenocorticotropic hormone that lacks the hormonal activity associated with the full-length peptide. Researchers at the Institute of Molecular Genetics in Moscow developed the compound during the 1980s. It has been registered as a pharmaceutical product in Russia and several neighbouring countries, where it is supplied as a nasal solution, and it is also sold internationally as a research chemical.
The proposed mechanism centres on neurotrophic signalling rather than direct receptor activation. Semax is reported to increase expression of brain-derived neurotrophic factor and nerve growth factor in several brain regions, and to shift the balance between excitatory and inhibitory neurotransmitter systems. Interaction with melanocortin receptors has been suggested because of the parent ACTH fragment. Many of these findings come from rodent studies, and the extent to which they translate to human physiology remains an open question.
Scientific literature on semax is unevenly distributed. A substantial share of published work originates from a small number of laboratories in Russia, while independent replication elsewhere is limited. Human data consist mostly of small trials with short follow-up, and several reported outcomes rely on subjective rating scales. Questions about how much intact peptide reaches the central nervous system after nasal administration, and how long it persists there, are still unresolved. The compound is best described as an active research subject rather than a settled pharmacological agent.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Published studies are dominated by animal models of stroke, ischemia, and cognitive impairment, with a smaller number of human trials conducted in Russia. Many of the human reports are small, single-center, and published in Russian-language journals, which limits independent scrutiny. Outcome measures vary between studies and often rely on clinician-rated scales rather than objective biomarkers. Systematic reviews have noted the methodological weaknesses and called for larger, preregistered trials before firm conclusions can be drawn.
Claims about enhanced focus, memory, or mood in healthy people rest mostly on anecdotal reports and community discussion rather than on controlled data. It remains unclear whether any cognitive benefit observed in patients recovering from brain injury would extend to uninjured users. Dose-response relationships, long-term safety, and interactions with other drugs are not well characterized in the peer-reviewed literature. Questions about optimal route of administration and treatment duration likewise remain open.
研究兴趣主要集中在神经营养因子相关的路径上，包括脑源性神经营养因子与神经生长因子的表达变化。部分实验报告称在特定条件下观察到这些因子的水平上升，但具体信号通路和剂量依赖关系仍未完全厘清。多数公开数据来自细胞模型和动物实验，人体对照研究数量有限。因此，该化合物的作用机制在文献中属于活跃讨论，而非已经确立的定论。
Semax 是一种人工合成的七肽，氨基酸序列为 Met-Glu-His-Phe-Pro-Gly-Pro，单字母缩写记作 MEHFPGP。它被归类为促肾上腺皮质激素片段 ACTH(4-10) 的结构类似物，但并不天然存在于生物体内。母体片段 ACTH(4-10) 的序列为 Met-Glu-His-Phe-Arg-Trp-Gly，Semax 替换了中间两个残基，并在羧基端延长了 Pro-Gly-Pro 三肽。这种延长被普遍认为能提升分子对肽酶的耐受性。
该化合物于二十世纪八十年代在俄罗斯被开发，相关工作由俄罗斯科学院分子遗传学研究所的研究团队主导。开发目标并非复制 ACTH 的完整激素活性，而是寻找保留其神经作用方向、同时去除促肾上腺皮质激素释放效应的短肽片段。研究记录显示，这一方向促成了多个相关短肽的合成与筛选，而 Semax 是其中被研究最广泛的一个。当地文献常以 Семакс 这一名称指代它。
=== Antibacterial activity === Lactoferrin's primary role is to sequester free iron, and in doing so remove essential substrate required for bacterial growth. Antibacterial action of lactoferrin is also explained by the presence of specific receptors on the cell surface of microorganisms. Lactoferrin binds to lipopolysaccharide of bacterial walls, and the oxidized iron part of the lactoferrin oxidizes bacteria via formation of peroxides. This affects the membrane permeability and results in the cell breakdown (lysis). Although lactoferrin also has other antibacterial mechanisms not related to iron, such as stimulation of phagocytosis, the interaction with the outer bacterial membrane described above is the most dominant and most studied. Lactoferrin not only disrupts the membrane, but even penetrates into the cell. Its binding to the bacteria wall is associated with the specific peptide lactoferricin, which is located at the N-lobe of lactoferrin and is produced by in vitro cleavage of lactoferrin with another protein, trypsin. A mechanism of the antimicrobial action of lactoferrin has been reported as lactoferrin targets H+-ATPase and interferes with proton translocation in the cell membrane, resulting in a lethal effect in vitro. Lactoferrin prevents the attachment of H. pylori in the stomach, which in turn, aids in reducing digestive system disorders. Bovine lactoferrin has more activity against H. pylori than human lactoferrin.
Hydrogen gas is produced in many types of fermentation as a way to regenerate NAD+ from NADH. Electrons are transferred to ferredoxin, which in turn is oxidized by hydrogenase, producing H2. Hydrogen gas is a substrate for methanogens and sulfate reducers, which keep the concentration of hydrogen low and favor the production of such an energy-rich compound, but hydrogen gas at a fairly high concentration can nevertheless be formed, as in flatus. For example, Clostridium pasteurianum ferments glucose to butyrate, acetate, carbon dioxide, and hydrogen gas. The reaction leading to acetate is:
Self was concerned that NAA had not ever designed a fighter, insisting they obtain the drawings and study the wind-tunnel test results for the P-40, before presenting them with detailed design drawings based on the agreed concept. NAA purchased the drawings and data from Curtiss for £56,000, confirming the purchase with the British Purchasing Commission. The commission approved the resulting detailed design drawings, signing the commencement of the Mustang project on 4 May 1940, and firmly ordering 320 on 29 May 1940. Prior to this, NAA only had a letter of intent for an order of 320 aircraft. Curtiss engineers accused NAA of plagiarism. The British Purchasing Commission stipulated armament of four .303 in (7.7 mm) machine guns (as used on the Tomahawk), a unit cost of no more than $40,000, and delivery of the first production aircraft by January 1941. In March 1940, 320 aircraft were ordered by Freeman, who had become the executive head of the Ministry of Aircraft Production (MAP) and the contract was promulgated on 24 April. The NA-73X, which was designed by a team led by lead engineer Edgar Schmued, followed the best conventional practice of the era, designed for ease of mass manufacturing. The design included several new features. One was a wing designed using laminar flow airfoils, which were developed co-operatively by NAA and the National Advisory Committee for Aeronautics (NACA). These airfoils generated low drag at high speeds.
Sources: en.wikipedia.org
In the 17th century Cossacks waged war against the Ottomans and the Crimean Khanate. In 1637 the Don Cossacks, joined by the Zaporozhian Cossacks, captured the strategic Ottoman fortress of Azov, which guarded the Don. The defense of the Azov Fortress in 1641 was one of the key actions in Don Cossack history. After total taking of the Free Territories of Don Cossacks under the Moscovy control, Don Cossack history became more intertwined with the history of the rest of Russia. In exchange for protection of the Southern borders of medieval Russia, the Don Cossacks were given the privilege of not paying taxes and the tsar's authority in Cossack lands was not as absolute as in other parts of Russia. During this period, three of Russia's most notorious rebels, Stenka Razin, Kondraty Bulavin and Emelian Pugachev, were Don Cossacks.
== Hemocyanin == Hemocyanin is a respiratory pigment that uses copper as its oxygen-binding molecule, as opposed to iron with hemoglobin. Hemocyanin is found in both arthropods and Mollusca, however it is thought that the molecule independently evolved in both phyla. There are several other molecules that exist in arthropods and Mollusca that are similar in structure to hemocyanin but serve entirely different purposes. For example, there are copper-containing tyrosinases that play significant roles in immune defense, wound healing, and the arthropod's cuticle. Molecules similar to hemocyanin in structure are grouped in under the hemocyanin superfamily.
ALN Magazine (ALN Mag.) ALN World (ALN World), no longer published Bioscience Technology (Biosci. Technol.) CED, formerly Communications, Engineering & Design Chem.Info Continuity Insights (Cont. Ins.), no longer an ABM brand Chromatography Techniques (Chromatogr. Tech.), no longer an ABM brand Controlled Environments Magazine (Control. Environ. Mag.) DFI News Digital Forensic Investigator (DFI News Digit. Forensic Investig.), no longer published Drug Discovery & Development (Drug Discov. Dev. also DDD Mag.) Electronic Component News (Electron. Compon. News also ECN) Food Manufacturing (Food Manuf.) Forensic Magazine (Forensic Mag.) Industrial Distribution (Ind. Distribution) Industrial Maintenance & Plant Operations (Ind. Maintenance Plant Oper.) Laboratory Design (Lab. Des.) Laboratory Equipment (Lab. Equip.) Manufacturing Business Technology (Manuf. Bus. Technol.) Manufacturing.net (Manuf. Net.) Medical Design Technology (Med. Des. Technol.) Pharmaceutical Processing (Pharm. Process.) Product Design & Development (Prod. Des. Dev.) R&D Magazine (R&D Mag.) Scientific Computing (Sci. Comput.) Surgical Products (Surg. Prod.) Wireless Design & Development (Wirel. Des. Dev.) Wireless Week (Wirel. Week)
=== Pests === Common tomato pests include the tomato bug, stink bugs, cutworms, tomato hornworms and tobacco hornworms, aphids, cabbage loopers, whiteflies, tomato fruitworms, flea beetles, red spider mite, Tuta absoluta (tomato leafminer), slugs, and Colorado potato beetles. The tomato russet mite, Aculops lycopersici, feeds on foliage and young fruit of tomato plants, causing shrivelling and necrosis of leaves, flowers, and fruit, possibly killing the plant. After an insect attack tomato plants produce systemin, a plant peptide hormone. This activates defensive mechanisms, such as the production of protease inhibitors to slow the growth of insects. The hormone was first identified in tomatoes.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Semax is based on the ACTH(4-10) fragment, a seven-amino-acid segment of adrenocorticotropic hormone. The synthetic peptide retains the core sequence while removing regions associated with endocrine activity. This modification is intended to isolate effects on the nervous system.